The
DigiRout 1000 Plus has high torque NEMA 34 square frame
steppermotors driven by state of the art DSP (Digital Signal Processor)
drives available for all axes
(double stack length on the X & Y& Z axes). The stepper
driver is based on a DSP with advanced control algorithm. It brings a
high level of system smoothness, providing optimum torque and nulls
mid-range instability. Motor auto-identification and parameter
auto-configuration technology offers optimum responses with different
motors and easy-to-use. The driven motors can run with much lower
noise, less heating, smoother movement than standard microsteppers and
are more economical than servomotors.
Heat Sink is included. High Performance, Based on DSP Algorithm. Anti-Resonance, provides optimum torque and nulls mid-range instability
• Motor auto-identification and parameter auto-configuration technology, offers optimum responses with different motors • Multi-Stepping allows a low resolution step input to produce a higher microstep output for smooth system performance • Microstep resolutions programmable, from full-step to 51,200 steps/rev, Can be set by Dip switch (2,4,8,16,32,64,128,5,10,20,25, 50,125) • Supply voltage up to +72 VDC • Output current programmable, from 0.5A to 7.0A(Can be set by Dip switch too) 2.6A,3.4A,4.0A,4.8A, 5.4A, 6.1A, 7.0A • Pulse input frequency up to 200 KHz • TTL compatible and optically isolated input • Full or Half Current , Sw4: Off= Half Current • Suitable for 2-phase and 4-phase motors • Support PUL/DIR and CW/CCW modes • Over-voltage, over-current, phase-error protection
One Year USA Warranty
Here is a video showing the smoothness and speed of the DSP drives: DSPDrives.wmv
